Additional look in this area has me puzzled. New Full install to ext2 at 14 Gigs on SDB3 achieves proper zd1211 drivers loading, but frugal to SDA1 (NTFS) or SDB1 (VFAT) both seem to miss the firmware. These were all created from the same folder of the extracted ISO 476c ???jduffy22335 wrote:The module appears to be loading and is not in the list of available modules, It does appear in the list of modules to blacklist, so I believe it is trying to load without success. Thanks.gposil wrote:Hi jduffy22335,
have you checked whether the zd1211rw kernel module is loading...check in wizard wizard, puppy startup
Note: moved up to the dup476c version.
To add more confusion, it seems I have leftover driver archives and extracted folders in root/tmp for "clean" no save install ! Could setup be not extracting the firmware correctly for frugal
Log info follows:
Frugal Install error:
phy0: Selected rate control algorithm 'pid'
ecb: Unknown symbol blkcipher_walk_done
ecb: Unknown symbol blkcipher_walk_virt
ecb: Unknown symbol crypto_blkcipher_type
phy0: Failed to initialize wep: -2
usb 8-5: reset high speed USB device using ehci_hcd and address 2
zd1211rw: probe of 8-5:1.0 failed with error -2
Full Install to sdb3 (ext2): Works !
usb 8-5: reset high speed USB device using ehci_hcd and address 2
phy0: Selected rate control algorithm 'pid'
zd1211rw 8-5:1.0: phy0
usbcore: registered new interface driver zd1211rw
Thanks for any insight, still learning ! Loving the Dpup