Bridging Network interfaces in Puppy 4.1 LLC modules needed
Posted: Thu 15 Jan 2009, 20:01
I am looking to bridge eth0 and tap0. Tap0 is used by an emulator running under Puppy.
I have found instructions for doing this in another forum (http://www.murga-linux.com/puppy/viewto ... 09765d3120). It was said that the kernel llc modules were missing. They were provided on that post, but this related to Puppy 3. The modules provided will not load under Puppy 4.
Does anyone have the llc modules for puppy 4?
Alternatively I am using the built in firewall's internet connection sharing to route traffic between the two networks eth0 and tap0. However some file sharing software running on the emulator on tap0 will not work. I am lead to believe this is because broadcasts are not being forwarded between the two networks. The file sharing software uses UDP. Anyone know how to forward broadcasts?
I have found instructions for doing this in another forum (http://www.murga-linux.com/puppy/viewto ... 09765d3120). It was said that the kernel llc modules were missing. They were provided on that post, but this related to Puppy 3. The modules provided will not load under Puppy 4.
Does anyone have the llc modules for puppy 4?
Alternatively I am using the built in firewall's internet connection sharing to route traffic between the two networks eth0 and tap0. However some file sharing software running on the emulator on tap0 will not work. I am lead to believe this is because broadcasts are not being forwarded between the two networks. The file sharing software uses UDP. Anyone know how to forward broadcasts?