besteht die Möglichkeit, VDR auf Puppy zum laufen zu bringen?
Bisher habe ich von der dotpups-Page die DVB-Treiber installiert
http://dotpups.de/dotpups/Multimedia/Mplayer-1.0rc1/
Über dmesg kann man auch erkennen, dass die Treiber geladen werden.
Code: Select all
unionfs: do delay copyup of "sis900.ko"
unionfs: do delay copyup of "i2c-core.ko"
unionfs: do delay copyup of "v4l1-compat.ko"
unionfs: do delay copyup of "v4l2-common.ko"
Linux video capture interface: v2.00
unionfs: do delay copyup of "videodev.ko"
unionfs: do delay copyup of "saa7146.ko"
unionfs: do delay copyup of "video-buf.ko"
unionfs: do delay copyup of "saa7146_vv.ko"
saa7146: register extension 'Multimedia eXtension Board'.
unionfs: do delay copyup of "mxb.ko"
unionfs: do delay copyup of "dvb-pll.ko"
unionfs: do delay copyup of "firmware_class.ko"
unionfs: do delay copyup of "dvb-core.ko"
b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully
unionfs: do delay copyup of "b2c2-flexcop.ko"
flexcop-pci: will use the HW PID filter.
flexcop-pci: card revision 2
ACPI: PCI Interrupt 0000:00:08.0[A] -> Link [LNKC] -> GSI 5 (level, low) -> IRQ 5
DVB: registering new adapter (FlexCop Digital TV device).
b2c2-flexcop: MAC address = 00:d0:d7:0e:ef:39
DVB: Unable to find symbol stv0299_attach()
DVB: Unable to find symbol mt352_attach()
DVB: Unable to find symbol nxt200x_attach()
DVB: Unable to find symbol lgdt330x_attach()
DVB: Unable to find symbol bcm3510_attach()
DVB: Unable to find symbol stv0297_attach()
DVB: Unable to find symbol vp310_mt312_attach()
b2c2-flexcop: no frontend driver found for this B2C2/FlexCop adapter
ACPI: PCI interrupt for device 0000:00:08.0 disabled
unionfs: do delay copyup of "b2c2-flexcop-pci.ko"
unionfs: do delay copyup of "drm.ko"
unionfs: do delay copyup of "sis.ko"
unionfs: do delay copyup of "messages"
unionfs: new lower inode mtime (bindex=0, name=log)
unionfs: do delay copyup of ".usb-drive-log-probedisk"
unionfs: do delay copyup of "usbcore.ko"
usbcore: registered new interface driver usblp
drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
Ein /usr/local/bin/scan -c ergibt aber, dass er kein DVB-Device findet:
main FATAL: failed top open '/dev/dvb/adapter0/frontend0': 19 no such device
Ist aber da und rechte sollten auch stimmen.
Was läuft noch schief?
Gruß
Michael[/code]