Now it works...
But i have the feeling that i'm still in vesa mode
Code: Select all
Driver "vesa" #card0driver
Code: Select all
Driver "vesa" #card0driver
Code: Select all
xorgwizard : lines ~317
.
.
#autoprobe...
# Patriot: skip any probing on QEMU; use preset instead
QEMUFlag=`dmesg | grep 'QEMU '`
if [ "$QEMUFlag" != "" ]; then
cp /etc/X11/app-defaults/Xqemuconf /root/xorg.conf.new
else
Xorg -configure > /tmp/xorgprobe.txt 2>&1
fi
#... config in /root/xorg.conf.new
.
.
Code: Select all
modprobe $MODULE $MPARAMS
Code: Select all
[ "$MODULE" != "mwave" ] && modprobe $MODULE $MPARAMS
Code: Select all
PCI_OVERRIDES='dmfe 0x00001282 0x00009102 #r_hughes reports tulip module not work.
mwave 0x00001014 0x0000007d #not in modinfo.
'
Apologies, didn't realize it was only for posting solutions since you requested test results here in this thread..But first, I think we should go back to your other thread so that we don't hijack this one, which is for offering fixes. Could you move this dialog back there and reduce the size of your above posts? I think everyone would appreciate that.
Code: Select all
mv -f /etc/resolv.conf /etc/resolv.conf.$$
Code: Select all
if [ -f /etc/resolv.conf.-2 ]; then mv -f /etc/resolv.conf.-2 /etc/resolv.conf.-3; fi
if [ -f /etc/resolv.conf.-1 ]; then mv -f /etc/resolv.conf.-1 /etc/resolv.conf.-2; fi
if [ -f /etc/resolv.conf ]; then mv -f /etc/resolv.conf /etc/resolv.conf.-1; fi