First I tried the USB-2.0-pcmcia-cardbus-card. I used the wakepup disk image to boot. And i found out that the USB-card works under freedos. So the question is: How come that it doesn't work under puppy wary 5?
This is lsmod-output:
- Module Size Used by
snd 56292 0
soundcore 7008 1 snd
usbhid 26944 0
usbcore 143472 1 usbhid
battery 9872 0
evdev 9536 0
serio_raw 5264 0
pcspkr 2348 0
apm 16648 1
fuse 58888 0
aufs 153580 480
nls_iso8859_1 3724 1
nls_cp437 5356 0
squashfs 22480 1
yenta_socket 23928 2
rsrc_nonstatic 11436 1 yenta_socket
nls_cp850 4524 1
- 00:00.0 Host bridge: PicoPower Technology National PC87550 System Controller (rev 02)
00:02.0 VGA compatible controller: S3 Inc. 86cM65 [Aurora64V+] (rev 43)
00:04.0 CardBus bridge: Texas Instruments PCI1131 (rev 01)
00:04.1 CardBus bridge: Texas Instruments PCI1131 (rev 01)
00:05.0 ISA bridge: PicoPower Technology PT86C523 [Vesuvius v3] PCI-ISA Bridge Slave
00:06.0 IDE interface: Silicon Image, Inc. PCI0643
- yenta_cardbus 0000:00:04.0: CardBus bridge found [0000:0000]
yenta_cardbus 0000:00:04.0: no PCI IRQ, CardBus support disabled for this socket.
yenta_cardbus 0000:00:04.0: check your BIOS CardBus, BIOS IRQ or ACPI settings.
yenta_cardbus 0000:00:04.0: ISA IRQ mask 0x06b8, PCI irq 0
yenta_cardbus 0000:00:04.0: Socket status: 30000006
yenta_cardbus 0000:00:04.1: CardBus bridge found [0000:0000]
yenta_cardbus 0000:00:04.1: no PCI IRQ, CardBus support disabled for this socket.
yenta_cardbus 0000:00:04.1: check your BIOS CardBus, BIOS IRQ or ACPI settings.
input: PS/2 Generic Mouse as /devices/platform/i8042/serio1/input/input1
yenta_cardbus 0000:00:04.1: ISA IRQ mask 0x06b8, PCI irq 0
yenta_cardbus 0000:00:04.1: Socket status: 30000020
pcmcia_socket pcmcia_socket1: cs: cardbus cards are not supported.
Any ideas to get the pcmcia-cards work?