Canon pixma printer drivers
Sorry, no change. Just tried installing on a fresh install of Macpup and also tried your advice from the last post and still only get an extra blank line in PPM and no driver in cups. I'm guessing it must be my system and don't get me wrong I love Macpup but I've been having troubles from the start with Macpup from my wireless card, getting puppy to sleep and wake properly.
I'm happy just to use the Gutenprint driver however because I've received so mush help from these forums I am more than happy to be your guinea pig if you think it will help others.
Cheers
I'm happy just to use the Gutenprint driver however because I've received so mush help from these forums I am more than happy to be your guinea pig if you think it will help others.
Cheers
Patriot wrote:Hmmm .....
The drivers listed below are my current attempt at merging some of the printer models defined from v2.50 - v2.70 into the v3.00 driver source. All drivers from v2.50 up-to v2.70 are gtk1 based and all drivers from v2.80 upwards are gtk2 based. Merging them should make our life simpler .....
Driver packages will be prepared only if there is a request for a particular model and also subject to time availability. No time frame is set for completion.
Please note that these packages should be considered to be preliminary tests drivers. Kindly report any issues that you may have when using these drivers. I will take note of the issues (if any) arising from these driver packages but please remember that I'm lame with C and a total klutz with GTK ..... debugging will take some time .....
Canon drivers merged into v3.00:
1. ip90 series download
2. ip1800 series download
3. ip2500 series download
4. ip3300 series download
5. ip4300 series download
6. mp160 series download
7. mp510 series download
8. mp600 series download
9. mp620 (stalled - no time frame set)
The IP90 is a dead link
- to be continued -
._.
Hey guys. I am trying to install to Puppy a Canon Mx320. Did not see in the CUPS wizard list. I tried installing an RPM but no go, thought it installed without error. Print job says complete but nothing printed. I must be missing something or doing something wrong.
I downloaded cnijfilter-mx320series-3.10-1-i386.rpm, and extracted with unrpm. Then I browsed to the ppd in the wizard to install. But I think there is another step I need to take? Newb sorry!
I downloaded cnijfilter-mx320series-3.10-1-i386.rpm, and extracted with unrpm. Then I browsed to the ppd in the wizard to install. But I think there is another step I need to take? Newb sorry!
canon LBP2900
Previously I had got this printer working in Lupu Plus. In Slacko & Precise the message I get is ccpdadmin command not found. :Please help