If your printer worked with Vanguard before you rebuilt your savefile why not just start over with a new one.starhawk wrote:Hey, rg, long time no chat.
Two questions.
(1) is there any chance of the next non-beta being released with say glibc2.19 instead of 2.17?
(2) and when do you expect it to be released?
Reason I'm asking is that rcrsn51 is trying to blame my current printer problems on Caro Vanguard (which is out-and-out BS, it worked fine on the same system, same config, until I rebuilt my savefile due to some other issues I was having) and there's not much I can do other than switch back to X-Slacko if I want help. (I'd like to say a few things about that, but I'm in public.)
Glibc-2.21 is in the Slackware current repo:
ftp://ftp.slackware.com/pub/slackware/s ... /slackware
Look in the "a" and "l" directory, if your try them please report back.
I'm not sure when the next release will be. After 7 betas I figured I needed a break.