did it bit by bit, echo ..
grep cell ->
Code: Select all
Channel:6
Code: Select all
grep "(Channel "
thanks and hope it helps
maddox
Code: Select all
Channel:6
Code: Select all
grep "(Channel "
Code: Select all
Channel=l6
Code: Select all
ifconfig rausb0 up
iwconfig rausb0 essid "1234567" channel 6 mode managed key off
iwconfig
Code: Select all
iwconfig rausb0 essid "1234567 " channel 6 mode managed key off
If i manually type the commands in rxtv the stick works fine.pwireless-1-IWCONFIG -> iwconfig essid "xxxxxxx " channel 6 ap key off bit auto rate auto txpower auto (no interface/device after iwconfig and no mode variable)
Pwireless-dhcp -> dhcpcd (no interface/device after command)
Code: Select all
iwconfig essid "" channel ap key ENTER-THE-KEY bit auto rate auto txpower auto
dhcpcd
Code: Select all
iwconfig rausb0 essid "" channel auto ap auto key ENTER-THE-KEY bit auto rate auto txpower auto
dhcpcd rausb0
Code: Select all
rxtv iwconfig output
rausb0 RT2500USB WLAN ESSID:"xxxxxxx" Nickname:""
Mode:Managed Frequency=2.437 GHz Access Point: xx:xx:xx:xx:xx:xx
Bit Rate=54 Mb/s
RTS thr:off Fragment thr:off
Encryption key:off
Link Quality=94/100 Signal level:-31 dBm Noise level:53 dBm
Code: Select all
mode managed
That's a known problem with older versions of the Ralink drivers. I contributed the fixed version of the rt2570 driver (compatible with Puppy2.17) here -maddox wrote:the iwconfig ESSID = "123456" but it should be ESSID = "1234567"
it's missing the last character (nber 7) of the ESSID