sorry not clear, did install your driver package from page 100.broadcom-sta-5.100.82.112-6_5.60.48.36-3_k2.6.33.2.petrerwin wrote:Thanks for your report. I do not see any indication that puppy recognized your wifi device. That suggests that the installation of the drivers did not trigger "depmod" to tell puppy of the new drivers. Pupscan associates the device with the proprietary driver, so a version of it must be present. Maybe it is the older version, which might not handle your device. Did you download the drivers before download number 8? If so, you would need to run depmod from a terminal/console. If your download was later than 7, then maybe the package logic to run depmod is faulty. Either way, try running depmod and rebooting.jim3630 wrote:installed lupulibre with driver package in the message for "arch_update-2" (on page 100)
and arch_update-3 frugal to ext4 hdd pfix=ram on dual p6100 hp laptop.
unable to connect wifi with sns or connection wizard.
eth1 nor wlan0 detected.
Richard
don't have a clue what is number 8?
nor what is later than 7...
and installed this lupuplus-528.001_arch_update-3.pet
so I would say these pets do not work with lupulibre and Broadcom Corporation BCM4313