[SOLUCIONADO] Veo mi RED pero NO se conecta
Posted: Mon 02 Jul 2007, 18:38
Acabo de intalar puppy linux 2.16 en un Compaq Armada m300 (P3 128mb Ram, 30Gigas)
Tiene puerto LAN y aparte tengo una tarjeta PCMCIA de Compaq. Pero en Network settings solo tengo eth0 pero al intentar configurarla "ve" que es un adaptador wifi y si doy a SCAN me "ve" la RED que tengo.
Intento configurar el ETH0 pero no hay manera. Le doy a SCAN y "ve" mi red, con lo que los drivers estan bien no? (lo he probado cargando el .inf y sin cargarlo)
Probando con RutilT wireless gadget, me sale:
Status: 3ComMurphy<---> 444444444444
Mode: Managed
Channel: 3 (2.422 GHz)
Tx rate: 11Mbps
Link quality: 0%
Signal level: -1.22 sBm
Noise level: -1.22 dBm
IP Address: N/A (mi red es DHCP)
Si voy a la pestaña de Site survey:
veo mi RED!! si pincho en ella y doy a Connect, me pide la KEY. Pero al meterla me da el error: (la clave SÉ que esta bien)
An eerror ocurred
Can't set WEP encryption with key: Index: 3
Code: 22
Alguien me puede ayudar?
He probado haciendo un perfil y tampoco
ACTUALIZACION:
It works!!! the only thing was to change the name! so stupid! If you have the same problem just DO THIS:
Add the name of your wireless network in the Profile Name field: for example: "WIFI"
Add the name of your wireless network in the ESSID field: this must be the name of you Wireless Name Network
Add the WEP key for your wireless network in the Key field: the KEY you must know
Just that! jejeje
Tiene puerto LAN y aparte tengo una tarjeta PCMCIA de Compaq. Pero en Network settings solo tengo eth0 pero al intentar configurarla "ve" que es un adaptador wifi y si doy a SCAN me "ve" la RED que tengo.
Intento configurar el ETH0 pero no hay manera. Le doy a SCAN y "ve" mi red, con lo que los drivers estan bien no? (lo he probado cargando el .inf y sin cargarlo)
Probando con RutilT wireless gadget, me sale:
Status: 3ComMurphy<---> 444444444444
Mode: Managed
Channel: 3 (2.422 GHz)
Tx rate: 11Mbps
Link quality: 0%
Signal level: -1.22 sBm
Noise level: -1.22 dBm
IP Address: N/A (mi red es DHCP)
Si voy a la pestaña de Site survey:
veo mi RED!! si pincho en ella y doy a Connect, me pide la KEY. Pero al meterla me da el error: (la clave SÉ que esta bien)
An eerror ocurred
Can't set WEP encryption with key: Index: 3
Code: 22
Alguien me puede ayudar?
He probado haciendo un perfil y tampoco
ACTUALIZACION:
It works!!! the only thing was to change the name! so stupid! If you have the same problem just DO THIS:
Add the name of your wireless network in the Profile Name field: for example: "WIFI"
Add the name of your wireless network in the ESSID field: this must be the name of you Wireless Name Network
Add the WEP key for your wireless network in the Key field: the KEY you must know
Just that! jejeje