Page 1 of 1
eee pc puppy getting tired
Posted: Wed 30 Apr 2008, 07:34
by jpa_cds
Puppy-eee 301 in use. . .
but wont go to sleep.
When booted from USB the batmon shows batery charge remaining. But when installed to the internal SD-HDD batmon just shows -%
And in either case the shutdown menu does not have suspend nor hibernate.
My search of this excelent (but very long) thread has not found a solution although I am confident that this has been done! Can someone point me in the right direction here?
Thanks very much
john./
Posted: Wed 30 Apr 2008, 09:20
by Aitch
Hi jpa_cds
Have a look at this, check your bios settings for acpi
Ray MK wrote:Only by using the acpi=force setting can I obtain any battery indication funtions in any of the display mediums such as conky, or tray's in Dingo, PupEee, Breezy or wmpower in any of the puppy's without conky or tray display for battery............just for interest - here is my current GRUB setup. They all run very happily together.
# Linux bootable partition config begins
title MinPup - frugal (on /dev/hda1)
root (hd0,0)
kernel /zMinPup/vmlinuz root=/dev/ram0 PMEDIA=idehd pdev1=hda1 ro vga=normal acpi=force
initrd /zMinPup/initrd.gz
# Linux bootable partition config ends
# Linux bootable partition config begins
title 216ce (on /dev/hda2)
root (hd0,1)
kernel /boot/vmlinuz root=/dev/hda2 ro vga=normal acpi=force
.....
snip
I think ACPI controls whether it will respond to a hibernate/sleep call
Aitch
Posted: Thu 01 May 2008, 04:41
by puppyluvr
Hello
Are you on a laptop? On my Compaq evo n610c I have to Boot ACPI=OFF in my GRUB for fan and battery control, else she overheats..If ACPI=FORCE doesnt solve your problem, you might try the other way..I dont use hibernate, since Puppy boots so fast, so I dont know how it affects that...Im sure it depends on the BIOS....
Good Luck...
Its how you install
Posted: Thu 01 May 2008, 06:35
by jpa_cds
Hi; thanks for your replies.
I just worked out that when I installed, I picked 'IDE HDD' as the target drive, rather than 'Flash card in IDE adapter'. So thats why my Puppy is running as if installed on a regular PC with magnetic disk drive - frequent disk access! And may explain why acpi is not working??
I'm ging to re-install Puppy on the flash drive and see where we go from there.
Cheers
john./
Posted: Thu 01 May 2008, 22:56
by Aitch
jpa_cds wrote:I'm g[o]ing to re-install Puppy on the flash drive and see where we go from there
.
You might find this useful
http://murga-linux.com/puppy/viewtopic.php?t=1360
Aitch