Page 1 of 1
Lucid 5.20 and Bluetooth?
Posted: Sat 19 Mar 2011, 20:51
by fanfare
Bluetooth is wireless after all, right?
Is there a comprehensive instruction on how to get Lucid to work with my bluetooth dongle to connect to the Internet via my phone?
I don't even know how to pair my devices.
Posted: Sat 19 Mar 2011, 23:17
by tempestuous
First you need to install Bluez and associated packages from here -
http://www.murga-linux.com/puppy/viewtopic.php?t=52973
fanfare wrote:... bluetooth dongle to connect to the Internet via my phone?
I'm not sure that the bluez-gnome gui supports this, but if not, I provided manual setup instructions here -
http://www.murga-linux.com/puppy/viewtopic.php?t=25009
refer to section 1) "Dial-up Networking Gateway"
Posted: Sun 27 Mar 2011, 14:25
by fanfare
Thanks tempestuous.
I'll give that a try.
Posted: Sun 27 Mar 2011, 14:41
by fanfare
OK, I followed the first set of instructions from:
http://www.murga-linux.com/puppy/viewtopic.php?t=52973
but libxcb-1.0.pet would not install. Also, when I rebooted my X-Windows were just frozen black with only my cursor showing, but nothing else on my desktop, not even the task bar.
I tried a fresh install on a brand-new puppy and left libxcb-1.0.pet out. That time it rebooted properly, but of course, I don't have libxcb-1.0.pet installed. But at least I know it was libxcb-1.0.pet that was causing my puppy to hang after bootup when the windows are supposed to display.
I am using Lucid Puppy 5.20.
Any ideas?
Thanks,
~fanfare