I have attached an updated "partview" script that calculates it's free value differently.
"free" is still calculated as "size" - "used", but it uses the size value from the output of "df" instead of the size value from "probepart".
Why? Please see the discussion of sizes etc in this post http://www.murga-linux.com/puppy/viewto ... 1&start=62.
I'm suggesting that both "partview" and "freememapplet_tray" show the actual "free" number.
Edit 19 Oct 2015:
The "partview" version here is consistent with "freemamapplet-2.8.6f". To provide consistency I've now added a "partview_avail.gz" to match "freememapplet-2.8.6".
To obtain the new script, unzip "partview_avail.gz" and then rename it to "partview".
(Sorry, I've been meaning to do this for a while.)
So please use this "partview.gz" and "freememapplet-2.8.6f",
or "partview_avail.gz" and "freememapplet-2.8.6".
Edit2:
Updated "partview_avail.gz" to be based on Tahrpup64 "partview".
gyro
An updated "partview" that shows the actual "free" space.
An updated "partview" that shows the actual "free" space.
- Attachments
-
- partview_avail.gz
- gunzip to produce the script "partview_avail" and then rename.
- (1.68 KiB) Downloaded 323 times
-
- partview.gz
- gunzip to produce the script "partview"
- (1.58 KiB) Downloaded 318 times
Last edited by gyro on Sun 18 Oct 2015, 21:30, edited 3 times in total.
Whew, I thought I was losing it.Flash wrote:You did but I moved it here. I'll put it back if you want, but isn't this the place for it?
I put it there because the idea is still experimental, and I tend to think of this area as being more for tried and true.
But by that logic I probably should have put the new freememapplet_tray stuff in "Cutting edge".
I'm happy to leave it here.
gyro
updated again
Updated "partview_avail.gz" to being based on the "partview" from Tahrpup64.
gyro
gyro